| 引用本文: | 丁宏,郑林华,雷菁,等.程控交换机硬件系统建模研究.[J].国防科技大学学报,2001,23(1):51-54.[点击复制] |
| DING Hong,ZHENG Linhua,LEI Jing,et al.The Research in the Hardware System Modeling of the Stored Program Controlled Telephone Exchange[J].Journal of National University of Defense Technology,2001,23(1):51-54[点击复制] |
|
| |
|
|
| 本文已被：浏览 6601次 下载 6294次 |
| 程控交换机硬件系统建模研究 |
| 丁宏, 郑林华, 雷菁, 韩方景 |
|
(国防科技大学 电子科学与工程学院, 湖南 长沙 410073)
|
| 摘要: |
| 底层功能实现模块是程控交换机多媒体仿真训练系统通用设计平台的关键部分。硬件配置是交换机工作的基础，是底层功能实现模块的重要组成部分。该文介绍了交换机硬件系统的建模，利用两种典型机型硬件实际的工作情况，解释并验证了所建立的通用功能流程图，并介绍了参数接口的管理与应用。 |
| 关键词: 底层功能实现模块 通用 功能流程图 |
| DOI： |
| 投稿日期：2000-10-20 |
| 基金项目:国家部委重点预研项目资助 |
|
| The Research in the Hardware System Modeling of the Stored Program Controlled Telephone Exchange |
| DING Hong, ZHENG Linhua, LEI Jing, HAN Fangjing |
|
(College of Electronic Science and Engineering, National Univ. of Defense Technology, Changsha 410073, China)
|
| Abstract: |
| The bottom function-realizing module is a key part of the Common Design Platform(CDP) of Multimedia Simulation and Training System(MSTS) for the Stored Program Controlled Telephone Exchange(SPCTE). Hardware configuration is the foundation of the SPCTE, the important part of the bottom function-realizing module. The modeling of the hardware of the SPCTE is proposed. Two typical SPCTE are used to explain and verify the models. The application of the models in the CDP is also given. |
| Keywords: the bottom function-realizing module common function flow chart |
|
|
|
|
|
