| 引用本文: | 龙永福,许静,张学骜,等.PMMA胶体晶体模板法制备有序大孔SiO2材料.[J].国防科技大学学报,2003,25(4):20-23.[点击复制] |
| LONG Yongfu,XU Jing,ZHANG Xueao,et al.Synthesis of Ordered Macroporous Silica Using Poly(Metyl Methacrylate) Colloid Crystal as Templates[J].Journal of National University of Defense Technology,2003,25(4):20-23[点击复制] |
|
| |
|
|
| 本文已被：浏览 6833次 下载 5955次 |
| PMMA胶体晶体模板法制备有序大孔SiO2材料 |
| 龙永福, 许静, 张学骜, 谢凯, 肖加余 |
|
(国防科技大学 航天与材料工程学院，湖南 长沙 410073)
|
| 摘要: |
| 以自制的单分散的聚甲基丙烯酸甲酯(PMMA)微球作为胶体模板，用正硅酸乙酯、水、乙醇、盐酸等配成溶胶,填充在微球间空隙，暴露在空气中24h凝胶、陈化。溶胶的配比为正硅酸乙酯∶水∶乙醇∶盐酸=6∶3∶4∶1(体积比)。然后通过程序升温焙烧去掉单分散的(PMMA)微球，可得有序SiO2大孔材料。程序升温控制的条件是以2℃/min的升温速率升到300℃，恒定5h，再以2℃/min的升温速率升到550℃，恒定10h，再以10℃/min的降温速率降到室温。 |
| 关键词: 微球 聚甲基丙烯酸甲酯 二氧化硅 胶晶 大孔材料 |
| DOI： |
| 投稿日期：2003-03-10 |
| 基金项目:国家教育部973项目(5130702002) |
|
| Synthesis of Ordered Macroporous Silica Using Poly(Metyl Methacrylate) Colloid Crystal as Templates |
| LONG Yongfu, XU Jing, ZHANG Xueao, XIE Kai, XIAO Jiayu |
|
(College of Aerospace and Materials Engineering, National Univ. of Defense Technology, Changsha 410073, China)
|
| Abstract: |
| The ordered macroporous silica was synthesized using PMMA latex sphere colloid crystal as template and sol of tetrarethyl orthosilicate,water,ethanol and hydrochloric acid as filling fluid.The sol was synthesized according to the volume ratio of Si(OEt) 4∶H2O∶EtOH∶HCl=6∶3∶4∶1. The latex spheres were removed by calcinations. Set the temperature program as follows: ramp the temperature at 2℃/min from the room temperature to 300℃, maintain it at 300℃ for 2 hours, ramp the temperature at 2℃/min from 300℃ to 550℃, maintain it at 550℃ for 10 hours, ramp the temperature at 10℃/min from 550℃ to the room temperature. |
| Keywords: latex sphere Poly(Metyl Methacrylate) silica colloid crystal macroporous |
|
|
|
|
|
