| 引用本文: | 谢海斌,龙志强,刘恒坤,等.利用线阵CCD自动测量MSBS中悬浮模型的位置与姿态.[J].国防科技大学学报,2004,26(4):107-111.[点击复制] |
| XIE Haibin,LONG Zhiqiang,LIU Hengkun,et al.Auto-measuring the Position and Attitude of the Model Suspending in MSBS by Applying CCD Array[J].Journal of National University of Defense Technology,2004,26(4):107-111[点击复制] |
|
| |
|
|
| 本文已被：浏览 7143次 下载 6152次 |
| 利用线阵CCD自动测量MSBS中悬浮模型的位置与姿态 |
| 谢海斌, 龙志强, 刘恒坤, 尹力明 |
|
(国防科技大学 机电工程与自动化学院，湖南 长沙 410073)
|
| 摘要: |
| 以我国自行研制的磁悬挂天平系统为背景，主要研究了利用线阵CCD传感器构建MSBS的模型位置与姿态测量系统以及相应的传感器配置方案、信号转换、测量原理和测量流程等问题。该系统的位置与姿态测量系统以两组共５片线阵CCD作为MSBS中悬浮模型的５自由度位置与姿态传感器，以串联的多级惯性环节电路为脉宽－电压转换电路，将测量信号分别输入控制回路和校准测量回路。文中详细介绍了５片CCD传感器的配置方案及其测量原理，然后研究了使用多级惯性环节实现脉宽－电压信号的转换问题，并对该方案进行了理论分析和仿真，最后研究了利用CCD的测量信号反演悬浮模型位置与姿态的数学原理及其自动测量流程。 |
| 关键词: CCD 磁悬挂天平系统；MSBS；位置姿态测量；脉宽信号；电平信号；转换 |
| DOI： |
| 投稿日期：2004-02-27 |
| 基金项目: |
|
| Auto-measuring the Position and Attitude of the Model Suspending in MSBS by Applying CCD Array |
| XIE Haibin, LONG Zhiqiang, LIU Hengkun, YIN Liming |
|
(College of Mechatronics Engineering and Automation, National Univ.of Defense Technology, Changsha 410073,China)
|
| Abstract: |
| Based on the magnetic suspension and balance system (MSBS), this paper mainly studies the problem of designing the position and attitude measurement subsystem of MSBS by CCD array sensors, and other relevant problems including sensors configuration, signal transformation, auto-measurement principle and flow. 5 CCD array sensors divided into two groups are used to measure the 5-degree freedom position and attitude of the model suspending in MSBS, and the multilevel inertial element circuits connected in series are used to transform the pulse width signal into voltage level signal. The position and attitude measurement subsystem of MSBS inputs its measurement signal to control loop and calibration & measurement loop of MSBS respectively. This paper introduces the configuration of 5 CCD array sensors and its measurement principle in detail. Then, the problem of the signal transformation using the multilevel inertial element circuits is discussed, and the theoretical analysis and simulation are presented. Finally, the mathematic principle and auto-measuring flow of achieving the position and attitude of the model suspending in MSBS by CCD array output signal are discussed. |
| Keywords: CCD Magnetic Suspension and Balance System(MSBS) measurement of position and attitude pulse-width signal level signal transformation |
|
|
|
|
|
