| 引用本文: | 陈健华.计算jn 组态总角动量J 允许值的递推方法.[J].国防科技大学学报,1989,11(2):55-60.[点击复制] |
| Chen Jianhua.A Recurrence Method for Calculating the Permitted J Terms of jn Configuration[J].Journal of National University of Defense Technology,1989,11(2):55-60[点击复制] |
|
| |
|
|
| 本文已被：浏览 5153次 下载 5297次 |
| 计算jn 组态总角动量J 允许值的递推方法 |
| 陈健华 |
|
(应用物理系)
|
| 摘要: |
| 计算jn 组态总角动量J的允许值通常采用列举法[1]，对j ，n大的组态计算十分繁琐。本文提出计算jn组态 J 的允许值的递推方法，使计算大为简化。在 VAX-ll/730机上完成 j=1/2～15/2 分类的CPU时间，用本文方法为 3 秒，用列举法[1]为 4分50秒。列出了j=1/2～15/2分类结果，并发现文献[2]表 6 有三处差错。 |
| 关键词: 原子物理，核物理，角动量，递推公式 jn组态 |
| DOI： |
| 投稿日期：1987-10-05 |
| 基金项目: |
|
| A Recurrence Method for Calculating the Permitted J Terms of jn Configuration |
| Chen Jianhua |
|
(Department of Applied Physics)
|
| Abstract: |
| The enumeration method is usually used to calculate the permitted J terms of jn configuration，but it becomes too complex to be used when the values of j，n become large enough. In this paper，a recurrence method instead of the conventional one is suggsted，thus greatly simplifying the calculation. For example，using this method it takes only 3 seconds of CPU time of the VAX-11/730 Computer to finish the classification of j=1/2～15/2，Whereas about 290 seconds are needed if the enumeration method is used. The classification results of j=1/2～15/2 have been listed in a table，and it is pointed out that there are 3 errors in the table of res.[2]. |
| Keywords: atomic physics,nuclear physics,angular momentum,recursion formula jn configuration |
|
|
