| 引用本文: | 何汉辉,王世民,潘仲明,等.活塞环非圆轮廓数控仿形加工系统及伺服机构设计.[J].国防科技大学学报,1997,19(5):64-69.[点击复制] |
| He Hanhui,Wang Shimin,Pan Zhongming,et al.Design of Non-Round Piston Ring NC Machining System and Its Servomechanism[J].Journal of National University of Defense Technology,1997,19(5):64-69[点击复制] |
|
| |
|
|
| 本文已被：浏览 6570次 下载 6005次 |
| 活塞环非圆轮廓数控仿形加工系统及伺服机构设计 |
| 何汉辉, 王世民, 潘仲明, 郄臣 |
|
(国防科技大学 机械电子工程与仪器系 湖南 长沙 410073)
|
| 摘要: |
| 本文简要综述了国内外活塞环理论研究及加工技术的发展状况，介绍了活塞环加工的一种新的方式和技术--活塞环非圆轮廓数控仿形加工系统的构成和工作原理， 详细论述了其伺服机构的设计，最后给出了实验结果。 |
| 关键词: 活塞环，加工，数控，伺服机构 |
| DOI： |
| 投稿日期：1996-12-17 |
| 基金项目:湖南省科技攻关计划重点资助项目 |
|
| Design of Non-Round Piston Ring NC Machining System and Its Servomechanism |
| He Hanhui, Wang Shimin, Pan Zhongming, Qie Chen |
|
(Department of Mechantronic and Instrumentation，NUDT，Changsha，410073)
|
| Abstract: |
| This paper summarises the developing situation of theoretic research and the technique of piston ring，and introduces a new method and technique for non-round piston ring contour NC machining and the construction and operating principle of this system. In this paper，the design of system's servomechanism is described. Finally，the results of the turning experiment are presented. |
| Keywords: piston ring,turning,NC,servomechanism |
|
|
|
|
|
