| 引用本文: | 李义和,傅圣利,王本根,等.Ni-P-SiC 化学复合镀.[J].国防科技大学学报,2000,22(5):33-36.[点击复制] |
| LI Yihe,FU Shengli,WANG Bengen,et al.Research of Ni-P-SiC Complex Chemical Plating[J].Journal of National University of Defense Technology,2000,22(5):33-36[点击复制] |
|
| |
|
|
| 本文已被：浏览 7087次 下载 5992次 |
| Ni-P-SiC 化学复合镀 |
| 李义和, 傅圣利, 王本根, 王清华 |
|
(国防科技大学 航天与材料工程学院, 湖南 长沙 410073)
|
| 摘要: |
| 采用化学共沉淀法对 Ni-P-SiC 化学复合镀研究, 通过能谱仪和扫描电镜分析了镀层的组成与形貌, 并对镀层的硬度、耐腐蚀性能进行了研究。结果表明, 镀层硬度随 SiC 微粒浓度加大而增加; 镀液中 SiC 微粒的浓度和镀液的 pH 值对镀层中 SiC 微粒的含量有影响; 在 SiC 浓度为 7.5g/L 时镀层中 SiC 含量达到最大值16.81%; 而 pH 值的最佳值为 4.7; 同时, 由于 SiC 微粒的加入, 镀层表面色泽变暗, 外观较粗糙, 镀层的耐腐蚀性降低。 |
| 关键词: 化学复合镀 SiC 耐腐蚀性 硬度 |
| DOI： |
| 投稿日期：1999-12-05 |
| 基金项目: |
|
| Research of Ni-P-SiC Complex Chemical Plating |
| LI Yihe, FU Shengli, WANG Bengen, WANG Qinghua |
|
(College of Aerospace and Materials Engineering, National Univ. of Defense Technology, Changsha 410073, China)
|
| Abstract: |
| Ni-P-SiC complex chemical platings were investigated by chemical co-deposition method. The composition and surface of the plate were analysized by XSP and SEM. The hardness and anti-corrosive abilities were also studied at the same time. The results showed that the plates' hardness increased with the increase of SiC concentration in the plating solutions. SiC concentration of plates were greatly influenced by plating solution concentration and its pH value. SiC concentration of plates got its top value, 16.81%, while SiC concentration in the plating solution was 7.5g/L and plating solution' pH value was 4. 7. However, the plates' surface became dim and rough, and the plates' anti-corrosive abilities decreased. |
| Keywords: SiC anti-corrosive abilities hardness |
|
|
|
|
|
