| 引用本文: | 杜刚,张明龙,曾竟成,等.气囊辅助RTM制备复合材料承力筒内腔尺寸控制技术.[J].国防科技大学学报,2006,28(6):11-16.[点击复制] |
| DU Gang,ZHANG Minglong,ZENG Jingcheng,et al.Precise Manufacture of Composite Bearing Cylinder by Bladder-assisted RTM Process[J].Journal of National University of Defense Technology,2006,28(6):11-16[点击复制] |
|
| |
|
|
| 本文已被：浏览 7199次 下载 5551次 |
| 气囊辅助RTM制备复合材料承力筒内腔尺寸控制技术 |
| 杜刚, 张明龙, 曾竟成, 刘钧, 彭超义, 肖加余 |
|
(国防科技大学 航天与材料工程学院，湖南 长沙 410073)
|
| 摘要: |
| 根据气囊充压压力与复合材料承力筒内径之间的变化关系，给出了成型复合材料承力筒内表面的气囊尺寸计算方程。分析了气囊充压压力增大对承力筒的壁厚、纤维含量和弯曲性能的影响。采用气囊辅助RTM工艺整体制备出复合材料承力筒。试验结果表明，气囊充压压力使复合材料承力筒的壁厚减薄，纤维体积含量增加，弯曲性能提高；选择适当的气囊充压压力可以制备出满足设计要求的复合材料承力筒。 |
| 关键词: 承力筒 树脂传递模塑(RTM) 气囊 复合材料 |
| DOI： |
| 投稿日期：2006-04-07 |
| 基金项目:国家863高技术资助项目(2002AA724052) |
|
| Precise Manufacture of Composite Bearing Cylinder by Bladder-assisted RTM Process |
| DU Gang, ZHANG Minglong, ZENG Jingcheng, LIU Jun, PENG Chaoyi, XIAO Jiayu |
|
(College of Aerospace and Materials Engineering， National Univ. of Defense Technology，ChangSha 410073，China)
|
| Abstract: |
| The equation for calculating Bladder dimension is derived based on the relationship between bladder pressure and the inner diameter of composite bearing cylinder. Effects of bladder pressure on the thickness, fiber volume fraction and bending properties of composite bearing cylinder were investigated. The composite bearing cylinder was manufactured by bladder-assisted resin transfer molding(BARTM) process. The experimental result shows that higher bladder pressure decreases thickness of composite bearing cylinder, increases fiber volume fraction and improves the bending properties. This indicates that composite bearing cylinder can be manufactured with precise inner diameter by BARTM process with a proper bladder pressure. |
| Keywords: bearing cylinder resin transfer molding(RTM) bladder composites |
|
|
