| 引用本文: | 丁凌艳,吴宇列,李圣怡.相位恢复镜面检测性能研究.[J].国防科技大学学报,2009,31(4):15-19.[点击复制] |
| DING Lingyan,WU Yulie,Li Shengyi.The Capability of Phase Retrieval Metrology for Mirrors[J].Journal of National University of Defense Technology,2009,31(4):15-19[点击复制] |
|
| |
|
|
| 本文已被：浏览 8009次 下载 5846次 |
| 相位恢复镜面检测性能研究 |
| 丁凌艳, 吴宇列, 李圣怡 |
|
(国防科技大学 机电工程与自动化学院，湖南 长沙 410073)
|
| 摘要: |
| 在镜面面形检测中应用相位恢复技术，可以简化测量系统，增强抗震动干扰能力。为确定相位恢复镜面测量系统的性能，从两个方面进行了研究。结合提出的相位恢复测量系统，运用傅立叶光学和几何光学理论讨论硬件对测量范围的限制，确定了CCD像素尺寸与被测镜 f 数，CCD整体尺寸与被测镜最大像差之间的定量关系。从算法效能角度，采用单因素仿真实验考察算法对镜面误差幅度和频率的适应性。仿真结果表明，表面误差频率在31.4mm附近时算法效率较高，过高或过低都将降低算法的效率；误差幅值的影响不大，镜面误差RMS值大至六个波长，小至百分之波长算法都可以胜任。 |
| 关键词: 光学制造 镜面检测 测量性能 傅立叶光学 相位恢复 |
| DOI： |
| 投稿日期：2009-05-10 |
| 基金项目:国家自然科学基金资助项目(50775217) |
|
| The Capability of Phase Retrieval Metrology for Mirrors |
| DING Lingyan, WU Yulie, Li Shengyi |
|
(College of Mechatronics Engineering and Automation, National Univ. of Defense Technology, Changsha 410073, China)
|
| Abstract: |
| Applying phase retrieval to mirror metrology can simplify the measurement system and increase the ability of resisting the vibration effects. The capability of phase retrieval testing system for mirrors is described from two aspects: its hardware and algorithm. According to the theory of Fourier optics and geometry optics, the pixel size and the total size of CCD spherically limit the f-number and the departure of a wavefront respectively. The adjustability of phase retrieval algorithm to different figure errors is observed afterward. A series of simulation experiments show that the algorithm is high-powered when the period of figure errors is about 31.4mm, and the performance is weaker when over or under that frequency; but the algorithm is reliable when the RMS value is up to six wavelength or as small as one percent wavelength. |
| Keywords: optical fabrication mirror test capability of measurement fourier optics phase retrieval |
|
|
