| 引用本文: | 蒋国庆,李家文,唐国金.参数化建模的螺栓法兰连接刚度分析.[J].国防科技大学学报,2014,36(6):180-184.[点击复制] |
| JIANG Guoqing,LI Jiawen,TANG Guojin.Stiffness analysis of bolted flange joint based on parameterized modeling[J].Journal of National University of Defense Technology,2014,36(6):180-184[点击复制] |
|
| |
|
|
| 本文已被：浏览 7858次 下载 6978次 |
| 参数化建模的螺栓法兰连接刚度分析 |
| 蒋国庆, 李家文, 唐国金 |
|
(国防科技大学 航天科学与工程学院，湖南 长沙 410073)
|
| 摘要: |
| 为分析几何参数对螺栓法兰连接刚度的影响，用MSC.Patran软件的二次开发工具PCL（Patran Command Language）建立了螺栓法兰连接的参数化模型。研究了螺栓法兰连接刚度随连接结构几何参数的变化规律并进行了灵敏度分析。经分析可知，连接结构刚度对开孔位置比例参数最敏感，其次是上法兰厚度。当上部段长度大于某一数值时，连接结构刚度对上部段长度参数不敏感，这一结论能为连接结构动力学简化建模提供一定理论参考。 |
| 关键词: PCL 螺栓法兰连接 参数化 灵敏度 |
| DOI：10.11887/j.cn.201406031 |
| 投稿日期：2014-06-30 |
| 基金项目: |
|
| Stiffness analysis of bolted flange joint based on parameterized modeling |
| JIANG Guoqing, LI Jiawen, TANG Guojin |
|
(College of Aerospace Science and Engineering, National University of Defense Technology, Changsha 410073,China)
|
| Abstract: |
| In order to analyze the effects of geometric parameters on the stiffness of bolted flange joint, a parameterized model of bolted flange joint was constructed by using PCL (Patran Command Language) on the platform of software MSC.Patran. The law of the stiffness of bolted flange joint with the change of geometric parameters was studied, and the sensitivity of geometric parameters was analyzed based on the parameterized model. The results show that the ratio of the location of hole is the most sensitive factor to the stiffness of bolted flange joint, and the next one is thickness of upper flange. When the length of upper body is up to a const, the stiffness of bolted flange joint is insensitive to the length of upper body, and this conclusion can provide a reference to simplify the dynamic model of joint. |
| Keywords: patran command language bolted flange joint parameterized sensitivity |
|
|
